< back

Highly Slip Resistant

buynow lattina_small_higly

HIGHLY SLIP RESISTANT

Highly Slip Resistant Sealer is an opaque solvent based sealer. This sealer has been specifically developed to have a grip like quality reducing the likelihood of slips even when the surface is wet.

Highly Slip Resistant Sealer has a semi-wet look finish ideal as a water repellent barrier around the swimming pool and slippery areas exposed to wet weather.


Features & Benefits:

  • Enhances the colour of pavers by creating an enduring “wet look”, enabling paving to retain its new appearance for years rather than months, as well as masking efflorescence bloom and preventing dusting.
  • The reduction in surface moisture reduces the likelihood of moss, weed, fungus and mildew growth.
  • Resists staining by spilled materials such as sump oils, fats, food, tyre marks, chewing gum etc. which enables easier cleaning and maintenance of coated areas.
  • Water runs off rather than soaking into the coated surface.
  • Produces a hard-wearing finish.
  • Penetrates below the surface giving protection in depth, and increases the life of the treated surface.
  • is clear and does not yellow in sunlight.
  • locks in the jointing sand in brick paving.

 

Recommended for:

  • Pavers – clay, concrete and reconstituted limestone (wet cast)
  • Reconstituted limestone blocks and feature walls
  • Natural limestone blocks and feature walls
  • Concrete floors, including exposed and honed aggregate surfaces
  • Pool headers and surrounds and water features (recommend re-sealing
    every twelve months)
  • Cladding (Stone and Slate)
  • All surfaces as specified above that are prone to Graffiti Tagging

 

Directions:

  • All surfaces and affected areas must be clean from dust, loose material and mortar spills.
  • Thoroughly hose down all affected areas.
  • Broom-in a chemical mix (generally acid etching) to affected areas,
    particularly stained, dirty or moss covered surfaces.
  • High pressure clean all affected areas. Repeat chemical mix on affected areas that are still marked if needed. Make sure to pressure clean it off immediately.
  • Allow no traffic on cleaned areas prior to sealing application.
  • Before applying Sealer, the affected areas must be completely dry.
  • Stir tin thoroughly before use. Apply two (2) coats of Sealer by roller or airless spray gun. Second coat to be applied as soon as first coat is dry. Depending on weather conditions, Sealer will dry underfoot within 1-3 hours. Heavy traffic areas (eg. Driveway/Carport) require up to three days drying time.
  • Clean brushes, rollers and airless spray guns with Cleaner.

A coverage rate of approximately 5-8m2 per litre on a smooth surface, however the porosity and texture of the surface and method of application may vary the coverage rate.

Any work carried out by persons other than Applicators cannot be guaranteed by .

SEALED SURFACES MAY BECOME SLIPPERY. CARE SHOULD BE TAKEN
Avoid use near naked flames or other sources of ignition. Ensure good ventilation during application of the product.

 

Download Material Safety Data Sheet

MSDS for solvent-based productsSlip Resistant Concrete Sealer

Check out our Latest Projects from our Instagram Feed

Privacy

By filling in and forwarding the contact form, you accept the following (in conformity with Legislative Decree no.196/2003 concerning privacy). All personal data provided are exclusively for internal use or for the proprietor’s communications and special offers. Your data will not be communicated or provided to third parties. The interested party enjoys specific rights according to Legislative Decree no.196/2003, article 7. To exercise these rights, the interested party should forward a request by email - info@purecoat.com.au